Nylon Cable Tie, 200x4.8 mm: The Complete Singapore Buyer's Guide [2026]
Table of Contentsexpand_more
A nylon cable tie, 200x4.8 mm is a general-purpose bundling tie measuring 200 mm in nominal length and 4.8 mm in width, sized for cable bundles up to approximately 50 mm in diameter. It suits control panels, data cabling, HVAC wiring and light industrial harnesses, and is available in natural or UV-resistant black nylon.
What exactly is a 200x4.8 mm nylon cable tie?
A 200x4.8 mm nylon cable tie is a one-piece, self-locking fastener moulded from nylon 6/6. The 200 mm figure is the nominal length from tail to head; the 4.8 mm figure is the strap width, which sets the tensile strength and the pawl engagement inside the head.
This size sits in the middle of the common range — heavier than a 100x2.5 mm micro tie used inside instruments, lighter than a 370x7.6 mm heavy-duty tie used on cable trays. Brands such as PANDUIT and BRADY set the benchmark for dimensional consistency and head strength in this class.
Quotable definition
A nylon cable tie, 200x4.8 mm is an all-purpose self-locking fastener with a 200 mm nominal length and 4.8 mm strap width, moulded from nylon 6/6, used to bundle and secure wires, cables and hoses up to roughly 50 mm bundle diameter in indoor and, when UV-stabilised, outdoor installations.
How does a nylon cable tie work?
The tail feeds through the head and a moulded pawl engages the serrated strap, locking at any point along its length. Pulling the tail tightens the loop; the pawl prevents reversal, so no tool is strictly required. A tensioning tool gives repeatable tightness on production lines.
Once locked, the tie is effectively permanent — it must be cut to release. That is why correct sizing matters: an undersized tie will not reach around the bundle, and an oversized tie leaves a long cut tail that can snag or chafe adjacent wiring.
Spec table: 200x4.8 mm nylon cable tie at a glance
| Attribute | Typical value | Notes |
|---|---|---|
| Nominal length | 200 mm | Tail to head, unstressed |
| Strap width | 4.8 mm | Sets tensile class |
| Material | Nylon 6/6 | Natural or black |
| Max bundle diameter | Approx. 50 mm | Depends on head geometry |
| Loop tensile strength | Approx. 22 kg (≈215 N) | Varies by manufacturer |
| Operating temperature | -40 °C to +85 °C | Continuous, nylon 6/6 |
| Flammability | UL 94 V-2 (natural nylon) | Confirm per brand datasheet |
| Pack quantity | 100 pcs or 1,000 pcs | Bulk packs for OEM lines |
Values above are typical for the 200x4.8 mm class. Always confirm the exact tensile and temperature rating against the manufacturer datasheet for the specific part you order.
Which nylon cable tie type suits your application?
Nylon ties come in three practical variants for Singapore buyers: natural (unpigmented) nylon for indoor use, UV-stabilised black nylon for outdoor and sun-exposed runs, and heat-stabilised or specialty grades for elevated-temperature environments.
- Natural nylon — control panels, switchrooms, data racks, indoor machinery. Lowest cost, no UV protection.
- UV-stabilised black nylon — rooftop HVAC, outdoor lighting, marine deck runs, exposed cable trays. Carbon black pigment resists UV degradation.
- Heat-stabilised nylon — near motors, ovens, or process equipment where ambient exceeds 85 °C.
In Singapore's humid tropical climate, UV-stabilised black ties are the safer default for anything outdoors or in semi-exposed plant areas, even if the run is short.
Selection criteria: how to choose the right tie
- Measure the bundle. Add up cable diameters and add 10–20% headroom. A 200x4.8 mm tie comfortably handles bundles up to about 50 mm.
- Match tensile to load. Static indoor wiring needs far less holding force than a vibrating machine harness or a suspended hose.
- Check the environment. Outdoors or in sun-exposed areas, specify UV-stabilised black nylon. Near heat sources, check the continuous temperature rating.
- Confirm compliance. For panels and equipment destined for regulated installations, verify UL recognition and flammability rating on the datasheet.
- Pick the pack size. 100-piece packs suit maintenance and MRO; 1,000-piece packs suit OEM and production lines.
- Consider tooling. High-volume lines benefit from a tensioning tool for consistent tightness and flush cut tails.
Product comparison: in-stock nylon cable ties at 3G Electric
| Product | Nominal length | Width | Max bundle dia. | Colour / outdoor use | Pack |
|---|---|---|---|---|---|
| PANDUIT All-Purpose Nylon Cable Tie, 4 in | 4 in (≈102 mm) | 0.1 in (≈2.5 mm) | 13/16 in (≈21 mm) | Gray / indoor only | 1,000 pcs |
| Intermediate Nylon Cable Tie, 7.9 in | 7.9 in (≈200 mm) | Intermediate | Not stated | Natural / indoor only | 100 pcs |
| PANDUIT UV-Resistant Black Nylon Cable Tie, 8 in | 8 in (≈203 mm) | 0.14 in (≈3.6 mm) | 2 in (≈51 mm) | Black / indoor & outdoor | 100 pcs |
| Natural Nylon Cable Tie, 10 in | 10 in (≈254 mm) | 0.14 in (≈3.6 mm) | 2 3/4 in (≈70 mm) | Natural / indoor only | 1,000 pcs |
| PANDUIT All-Purpose Nylon Cable Tie, 14 1/2 in | 14 1/2 in (≈368 mm) | 0.19 in (≈4.8 mm) | 4 in (≈102 mm) | Natural / indoor only | 1,000 pcs |
Step up the ladder when bundle diameter grows, when the run moves outdoors, or when tensile demand rises. The 200x4.8 mm class sits between the intermediate 7.9 in tie and the 10 in natural tie — if your bundle is under 50 mm and stays indoors, the intermediate size is the closest match; if it goes outdoors, move to the UV-resistant black tie.
Where does a 200x4.8 mm tie fit in Singapore industry?
Singapore's precision manufacturing, marine and offshore yards, F&B plants and pharmaceutical facilities all rely on this size class. Panel builders use it inside control cabinets; marine electricians use UV-stabilised versions on deck; F&B maintenance teams use natural nylon inside washdown-adjacent enclosures where the tie stays dry.
For cable runs crossing vehicle or pedestrian traffic — common in shipyards and event venues — pair ties with a proper cable ramp such as the LINEBACKER 1-Channel Drop-Over Cable Ramp or the ELECTRIDUCT 1-Channel Rubber Cable Ramp. Ties secure the cable; ramps protect it from crush loads.
Why source nylon cable ties from 3G Electric in Singapore?
3G Electric stocks 133+ products across 14 industrial departments — from cable ties and cable ramps to pumps, controls and combustion components. With 35+ years of experience, we interpret your requirement, confirm the right spec, and quote from Singapore stock for fast local delivery.
We are a distributor and supplier, not an authorised dealer for every brand we carry. That means we give you the honest answer on what fits — and we stand behind what we ship.
Key takeaways
- A 200x4.8 mm nylon cable tie bundles cables up to roughly 50 mm diameter with about 22 kg loop tensile.
- Choose natural nylon for indoor panels; UV-stabilised black nylon for outdoor or sun-exposed runs in Singapore.
- Confirm tensile, temperature and flammability ratings on the manufacturer datasheet before specifying.
- Buy 100-piece packs for MRO and 1,000-piece packs for production lines.
- 3G Electric supplies from Singapore stock with technical support and fast local delivery.
Next step
Contact 3G Electric for a quote on nylon cable ties, sizing assistance, or help matching ties to cable ramps and panel accessories. Tell us your bundle diameter, environment and pack quantity, and we will confirm the right part from stock.

![Nylon Cable Tie, 200x4.8 mm: The Complete Singapore Buyer's Guide [2026]](https://oxalncjenpflyqfncuhe.supabase.co/storage/v1/object/public/product-assets/grainger/cfc005f9-3d92-44e1-a4a7-05a2f976cac4.jpg)


